HIGHSIDER pro license plate holder Akron-RS

HIGHSIDER AKRON-RS license plate holder for HONDA CB 1000 R, 21-, without license plate light

The HIGHSIDER AKRON-RS license plate holder adapts perfectly to the lines of your bike thanks to its design.

The model-specific bracket of the HIGHSIDER AKRON-RS allows it to be fitted to the original mounting points of your bike, meaning it can be replaced without drilling or cutting.
To prevent damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet.

The license plate is made of sheet steel and is 2 mm thick. It is precisely cut to size using a laser. After edging, a weather-resistant black powder coating is applied.
This ensures optimum fit and durability.
Thanks to the infinitely variable adjustment option, you can place the panel in the desired position without drilling. There is an additional locking screw to hold the plate in this position.

The blinker brackets of the HIGHSIDER AKRON-RS are adjustable in width and therefore suitable for all types of accessory indicators. This adjustment option allows you to adapt the position of your indicators to a wide variety of license plates. To enable the indicators to be fitted without disconnecting them from the wiring harness, the 8 mm holes are slotted to the side.

You can also individually adjust the position of the rear reflector using a slider. Adaptation to the different versions of EU license plates is therefore no problem.

Two rubber washers are included to securely screw the license plate in place and reduce vibrations. A further rubber buffer supports the license plate on its underside.

Details:

- Model-specific bracket
- Infinitely adjustable blinker holder
- slotted blinker holder for easy mounting without cable separation
- infinitely adjustable reflector, E-approved
- Suitable for European license plates
- Infinitely adjustable angle of inclination
- Additional screw for optimum positional security
- Simple fixing without further work steps (e.g. drilling)
- Simple mounting of the license plate thanks to slotted holes

The scope of delivery of the HIGHSIDER AKRON-RS includes

- Model-specific bracket with mounting parts
- HIGHSIDER AKRON-RS license plate mounting plate
- Adjustable blinker brackets
- E-approved reflector with adjustable bracket
- Fitting instructions

Notes:
- If side reflectors are fitted to your original license plate holder, these must be refitted in a suitable position or replaced with new ones.
- Special blinker holders are optionally available for the original indicators.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are certainly a good alternative.