HIGHSIDER pro license plate holder Akron-RS Pro-X Yamaha

HIGHSIDER AKRON-RS PRO-X license plate holder incl. rear light

The AKRON-RS PRO-X license plate holder is designed to perfectly match the lines of your bike.

The model-specific holder of the AKRON-RS PRO-X enables mounting on the original mounting points of your bike and thus replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged feed-throughs are protected by a rubber grommet.

The license plate is made of 2 mm thick sheet steel and precisely laser-cut. After edging, it is given a weather-resistant, black powder coating.
This ensures an optimum fit and a long service life.
The stepless adjustment option allows you to position the plate as required without drilling. The plate is held in this position by an additional locking screw.

The width of the AKRON-RS PRO-X blinker brackets can be adjusted and are therefore suitable for all types of accessory indicators. This adjustment option allows you to adapt the position of your indicators to a wide variety of license plates. The M8 through-holes are slotted to the side to allow the indicators to be fitted without disconnecting them from the wiring harness.

You can also individually adjust the position of the rear reflector using a slider. This makes it easy to adapt to the different versions of EU license plates.

Two rubber washers are included to securely screw the license plate and reduce vibrations. A further rubber buffer supports the license plate on its underside.

This PRO-X version of the AKRON-RS includes the very small HIGHSIDER rear light milled from high-quality aluminium with mounting plate and support arm. The bracket is adjustable in height and designed so that it can be mounted in the legally prescribed position.

Details:
- model-specific bracket
- infinitely adjustable blinker holder
- slotted blinker holder for easy mounting without cable separation
- infinitely adjustable reflector, E-approved
- suitable for European license plates
- infinitely adjustable angle of inclination
- additional screw for optimum positional security
- easy to fix without further work steps (e.g. drilling) 5 - easy to install without additional work steps (e.g. drilling).E.g. drilling)
- simple mounting of the license plate through elongated holes
- rear light incl. holder included in delivery Bracket included in scope of delivery
- rear light, E-approved
- infinitely adjustable license plate light
- many different options for mounting the rear light

The AKRON-RS PRO-X scope of delivery includes:
- Model-specific bracket with mounting parts
- AKRON-RS license plate mounting plate
- Adjustable blinker brackets
- E-approved reflector with adjustable bracket
- E-approved rear light
- Fitting instructions

Rear light assignment:
- White = license plate light
- Black = ground
- Red = brake light
- White = tail light
- Black = ground

Notes:
- Since the original tail light of your motorcycle is omitted when mounting this license plate holder, we offer you this set including a new tail light and a matching tail light. a new rear light and suitable adapter cable.
- If side reflectors are fitted to your original license plate holder, these must be refitted in a suitable position or replaced with new ones.
- For the original indicators, we offer you an optional special blinker holder, also in the Accessories tab.

Tip:
If you have not found a model-specific license plate holder for your vehicle, you are sure to find one among the universal license plate holders from HIGHSIDER, which are available in many different designs.