HIGHSIDER pro license plate holder Akron-RS Without lighting

HIGHSIDER AKRON-RS license plate holder

The HIGHSIDER AKRON-RS license plate holder adapts perfectly to the lines of your bike thanks to its design.

The model-specific holder of the HIGHSIDER AKRON-RS enables mounting on the original mounting points of your bike and thus replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet.

The license plate is made of sheet steel and is 2 mm thick. It is precisely cut to size using a laser. After edging, it is given a weather-resistant black powder coating.
This ensures an optimum fit and durability.
The stepless adjustment option allows you to position the plate as required without drilling. There is an additional locking screw to hold the plate in this position.

The width of the blinker brackets on the HIGHSIDER AKRON-RS can be adjusted and are therefore suitable for all types of accessory indicators. This adjustment option allows you to adapt the position of your indicators to a wide variety of license plates. The 10 mm holes are slotted to the side to allow the indicators to be fitted without disconnecting them from the wiring harness.

You can also individually adjust the position of the rear reflector using a slider. This makes it easy to adapt to the different versions of EU license plates.

Two rubber washers are included to securely screw the license plate and reduce vibrations. Another rubber buffer supports the license plate on its underside.

Details:

- Model-specific bracket
- Infinitely adjustable blinker holder
- Slotted blinker holder for easy installation without cable separation
- Infinitely adjustable reflector, E-approved
- Suitable for European license plates
- Infinitely adjustable tilt angle
- Additional screw for optimum positional security
- Easy to fix without additional work steps (e.g. drilling) 5 - Includes two rubber washers.E.g. drilling)
- simple mounting of the license plate through slotted holes

The scope of delivery of the HIGHSIDER AKRON-RS includes

- Model-specific bracket with mounting parts
- HIGHSIDER AKRON-RS license plate mounting plate
- Adjustable blinker brackets
- E-approved reflector with adjustable bracket
- Installation instructions

Notes:
- If side reflectors are fitted to your original license plate holder, these must be refitted in a suitable position or replaced with new ones.
- The special 280-978 blinker holder is optionally available for the original indicators.

Tips:
If you have not found a model-specific license plate holder for your vehicle, you are sure to find one among the universal license plate holders from HIGHSIDER, which are available in many different designs.