HIGHSIDER pro license plate holder

HIGHSIDER pro license plate holder incl. license plate light

The design of the license plate holder adapts perfectly to the lines of your bike.

The model-specific bracket allows mounting on the original mounting points of your bike and thus replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet.

The license plate is made of 2 mm thick sheet steel and precisely cut by laser. After edging, a weather-resistant black powder coating is applied.
This ensures optimum fit and durability.
Thanks to the infinitely variable adjustment option, you can move the plate to the desired position without drilling. The plate is held in this position by an additional locking screw.

The width of the blinker brackets can be adjusted and are therefore suitable for all types of accessory indicators. This adjustment option allows you to adapt the position of your indicators to a wide variety of license plates. To enable the indicators to be fitted without disconnecting them from the wiring harness, the M8 through-holes are slotted to the side.

You can also individually adjust the position of the rear reflector using a slider. Adaptation to the different versions of EU license plates is therefore no problem.

Two rubber washers are included to securely screw the license plate and reduce vibrations. A further rubber buffer supports the license plate on its underside.

This version includes the very small HIGHSIDER license plate light milled from high-quality aluminium with mounting plate and support arm. The bracket is adjustable in height and designed to allow mounting in the legally prescribed position.

Details:
- Model-specific bracket
- Infinitely adjustable blinker holder
- slotted blinker holder for easy mounting
- infinitely adjustable reflector, E-approved
- Suitable for European license plates
- Infinitely adjustable angle of inclination
- Additional screw for optimum positional security
- Simple fixing without further work steps (e.g. drilling)
- Simple mounting of the license plate thanks to slotted holes
- License plate light incl. holder included in the scope of delivery
- License plate light, E-approved
- Infinitely adjustable license plate light
- Many different options for attaching the license plate light

Included in the scope of delivery:
- Model-specific bracket with mounting parts
- License plate mounting plate
- Adjustable blinker brackets
- E-approved reflector with adjustable holder
- E-approved license plate light incl. holder
- Mounting instructions

License plate light assignment:
- White = Plus
- Black = ground

Notes:
- As the original rear light of your motorcycle is omitted when mounting this license plate holder, we offer you a suitable replacement in the accessories tab. There you will find our modern and road-approved 3in1 combinations.
- If you would prefer to have a central rear light, we can offer you our SPLIT rear lights. You can simply replace them with the license plate light supplied, as this function is also covered by the rear lights. You can also find the rear lights in the accessories tab.
- If side reflectors are fitted to your original license plate holder, these must be refitted in a suitable position or replaced with new ones.
- For the original indicators, we offer you an optional special blinker holder, also in the Accessories tab.